Gigamon GigaVUE TA Series, Hardware Installation Manual

Page: 60 / 108

60 GigaVUE TA Series Hardware Installation Guide
Changing the Console Port’s Speed
By default, the console port operates at 115,200bps. You can change the
speed of the console port to 9600bps on the GigaVUE-TA10 and
GigaVUE-TA40 with the
serial baudrate <9600 | 115200> command.
Keep in mind the following points when changing the console port’s speed:
• After changing the console port’s speed, you must save the active
configuration and reload the system for the change to take effect.
• After setting the console port to 9600bps, the u-boot output will appear
correctly on the connected serial console. However, you will need to
press the spacebar once or twice for the CLI login prompt to appear.
• You can use the show serial baudrate command to view the currently
configured console port speed.
Run the Jump-Start Script
Gigamon provides the GigaVUE nodes with a jump-start script that walks
you through the process of configuring basic settings. Run this script as
follows:
1.
Switch to Config mode.
There are three command entry modes, each with increasingly powerful
rights –
Standard , Enable , and Config . The jump-start script is only
available in config mode:
a.
Type en <Enter> to switch to Enable mode.
The system prompt changes from [hostname] > to [hostname] # .
b.
Type config t <Enter> to switch to Config mode.
The system prompt changes from [hostname] # to [hostname]
(config) # .
2.
Reset the terminal settings to match the current window with the following
command:
terminal resize
3.
Type config jump-start to run the jump-start script.
4.
Follow the jump-start script’s prompts to set each of the settings listed
below.