![background image](http://html1.mh-extra.com/html/gigabyte/r182-n20/r182-n20_user-manual_2225287036.webp)
System Hardware Installation
- 33 -
3-7 Installing the Mezannine Card
3-7-1 Installing the OCP 3.0 Mezzanine Card
Use of the following type of OCP 3.0 NIC is recommended:
•
OCP 3.0 SFF with Pull Tab
•
OCP 3.0 SFF with Ejector Latch
Follow these instructions to install an OCP 3.0 mezzanine card:
1. Remove the two screws securing the mezzanine card slot cover.
2. Remove the slot cover from the system.
3.
Insert the OCP 3.0 mezzanine card into the card slot ensuring that the card is firmly connected to
the connector on the motherboad.
4. Tighten the thumbnail screw to secure the OCP 3.0 mezannine card in place.
5. Reverse steps 3-4 to replace the OCP 3.0 mezzanine card.
2
1
1
4
3
Summary of Contents for R182-N20
