GHOST
User Manual Status 04/2009 // Spec 2010
10.119
2.
With carbon saddle post and saddle tube:
•
The clamping area must be free from grease, or use a special installation
paste for carbon parts.
3.
Push the saddle with saddle post into the saddle tube of the frame until the
required saddle height is obtained. In this position the lower end of the saddle
post must be at least 10 cm below the upper edge of the saddle tube.
Do not rely on the marking on the saddle post.
Check the correct insertion depth as follows:
-
Place a finger tip against the saddle post in installed condition
immediately above the clamping bolt.
-
Leave your finger in this position and pull the saddle post out of
the saddle tube.
-
Hold the saddle tube alongside the saddle tube so that your
finger is again at the height immediately above the clamping
bolt.
-
In this position the lower end of the saddle post must be at
least 10 cm below the upper edge of the saddle tube.
Summary of Contents for Bike
