GGP WBE 0701, Workshop Manual

Page: 30 / 56

pag. 0
Release 00 - 02/2008
Engine WBE 0701-WBE 0704
Service manual
7 - Perform a spark test as indicated in [
10.1] .
- If the spark jumps: the coil functions properly and
in the event of malfunction, verify that the cut-off
cable (1) is not earthed.
- if the spark does not jump: the coil is faulty and
must be replaced [ 10.] .
8 - Refit the starter assembly [ 6.1] .
10.. Replacing the coil
1 - Remove the starter assembly [ 6.1] .
2 - Disconnect the faston of the earth cable (6).
3 - Undo the screw (9) and the stud (10) and remove
the coil (7).
4 - Mount the new coil and regulate the air gap
according to the procedure indicated in points 4
and 5 in section [ 10.2] .
5 - Connect the faston of the earth cable (6).
8 - Refit the starter assembly [ 6.1] .
Tightening torques
1 Spark plug tightening torque 16-18 Nm
9 Coil fixing screw 8-10 Nm
10 Coil fixing stud 8-10 Nm
Technical information
Type of spark plug RC12YC (Champion) or equivalent
Distance between electrodes
0,6-0,8 mm
Air gap/flywheel 0,25-0,40 mm
Special equipment
Tester for spark test
10. IGNITION
10
6
7
1
9
<< BACK >>
back to the index