Gerber Sabre Engraver Option, Manual

Page: 9 / 29

4 Engraver Option
Installing the Engraver Option
This section provides procedures for:
„
removing and reinstalling the standard router motor or high frequency
spindle
„
mounting and removing the engraver
„
changing the engraver nose cones
Removing the motor or spindle
Note: The word "motor" in the following procedure refers to either the
standard router motor or the high frequency spindle. They are both removed
from the carriage in the same way.
1. Shut off power to the Sabre by turning off the main power breaker on the
electrical cabinet.
2. Unplug the motor power cord from the carriage.
3. Remove any tool or collet in the motor.
4. Disconnect the chip removal system vacuum hose from the vacuum shroud
and tuck it behind the carriage.
5. Remove the pressure foot and vacuum shroud from the carriage by
removing two screws from each side of the shroud. Store the screws with the
shroud.
6. Unhook and remove the side springs.