Gerber Sabre Engraver Option, Manual

Page: 23 / 29

18 Engraver Option
Note: If nose cone scuffing of softer material is a concern, set the nose
cone about 1/4" (6 mm) above the material surface to prevent the cone from
contacting and scuffing the material surface.
7. Install the cutter as described on page 13.
8. Press the TABL Z INIT on the control pad. The display reads:
TABLE INIT 1/2
0.063 in (thick)
A: Increase
B: Decrease
9. Look at the file in ART Path to determine the tool depth that you entered.
CAUTION: When performing the next step, enter the same material
thickness as the tool depth entered in ART Path. If the number is not
the same, the table protection feature will not be effective.
10. Enter the material thickness by pressing the A or B key to increase or
decrease the number.
Note: Material thickness can range from .063" to 6.0" in .063" increments
(16 mm to 150 mm in 152 mm increments).
11. Press ENTER. The display reads:
TABLE INIT 1/2
Init from table
A: Initialize
12. Press A to initialize the spindle.
13. Remove the gage.
14. Verify that the engraver motor is turned on.