Gerber Sabre Engraver Option, Manual

Page: 16 / 29

Using the Engraver Option 11
Using the Engraver Option
This section presents information and procedures for operating the Engraver
Option as follows:
„
the two operating modes
„
installing cutting tools
„
initializing for different types of engraving
„
changing the cutter rpm
Operating modes
The Engraver Option has two operating modes
−
float mode and fixed mode.
Float mode
The float mode is used for most engraving operations. The nose cone is in
constant contact with the material surface and follows the surface contours. This
results in a uniform cut depth and width even if the surface is not perfectly flat.
To operate the engraver in the float mode, refer to "Setting up and initializing for
different types of engraving" on page 14.