Gerber Sabre Engraver Option, Manual

Page: 7 / 29

2 Engraver Option
Unpacking the Engraver Option
The engraver motor and casting are attached to a palette with two screws. Use a
Phillips screwdriver to remove the screws and save the screws and pallet.
After unpacking, inspect the following:
1. Verify that the part numbers on the packing slip and invoice match the part
numbers on the motor.
2. Verify that the kit contents listed below have been received.
3. Check for shipping damage. If any part of the engraver is damaged or
missing, notify the shipper immediately.
Kit contents
1 engraver motor and casting
1 mounting plate
4 M6 x 45 screws
4 M6 x 25 screws
8 M6 washers
4 M6 lock washers
20 tie wraps
6 self-adhesive power cord clips
1 cutter knob wrench (handle and separate spline insert)
1 cleaning brush
1 .03" or .75 mm diameter engraving cutting tool
1 .06" or 1.5 mm diameter engraving cutting tool
1 spare drive belt
1 vacuum nose cone
1 pressure foot with foam ring
1 spare foam ring
a vacuum hose for use with the Engraver Vacuum Option