25
The lower table on the machine is interchangeable. Different sized
optional tables can be obtained for various materials & handling
requirements.
The tables simply fit right onto the
bottom pedestal. There are two steel
pins that look like “bullets” that fit
into the two corresponding holes
in the bottom tables. They may be
tight from the factory, and can be
reamed out to allow for a looser fit
and faster change-out.
Custom lower tables and pedestals are available from the factory for
specific needs. Tongue-style pedestals with the support at the rear are
often requested for pocket/bag loading applications. These “diving-
board” anvil style pedestals are especially helpful with hard-to-load
applications.
Interchangeable Tables
Maintenance
The majority of the press has been designed to be as maintenance free
as possible. There are only a few aspects of the machine that should be
monitored to insure proper operation.
•. The.clamp/linkage.assembly.is.the.greatest.area.of.wear.and.friction.on.the.
press..The.post.that.connects.to.the.heat.platen.should.be.lubricated.with.
SuperLube.-.a.clear.high-temperature.lubricant.
•. If.the.pins.in.the.clamping.mechanism.wear,.or.the.holes.become.elongated,.
eventually.the.press.will.not.lock.properly..This.can.be.very.detrimental.
to.pressing.results.&.quality!.Contact.the.factory.for.a.very.inexpensive.
clamp.replacement.to.get.the.clamps.back.to.new.condition.
•. The.silicone.pad.on.the.lower.table.can.degrade.after.much.use.and.over.
an.extended.period.of.time..This.pad.is.replaceable..If.the.pad.becomes.
dried.out,.cracked,.or.there.are.chunks.removed.from.the.silicone.pad,.this.
can.result.in.inconsistent.and.poor.quality.transfers.
Parts / Maintenance / Misc
