geo-FENNEL 211001, User Manual

Page: 27 / 62

27
EN
V-W-S MODE (VIBRATION-WIND-SECURITY)
Press the key , to switch on the V-W-S mode. A red LED will show that this mode is activated. The
V-W-S mode allows continuous operation during strong wind, vibrations and shocks. Slight movements
will be ignored, only if significant movement occurs the laser stops rotating as the V-W-S mode works
with the activated TILT function. Press the key again to switch this mode off.
SLOPE FUNCTION
This mode can only be operated with the remote control:
Press the key once to tilt the X axis with buttons (1) (LED of X axis on the instrument is blinking).
Press the key twice to tilt the Y axis with buttons
(1)
(LED of Y axis on the instruments is blinking.
Press the key to quit the slope function. The LED will power off.
Important: If the slope angle is beyond the self-levelling range the slope process stops and an alarm
signal sounds.
When it is in SLOPE mode the unit will automatically leave the TILT mode.
SHIELD FUNCTION
With the buttons (I) of the instrument or (4) of the remote control the laser beam can be shielded in
all four directions - however, in max. three directions at the same time. This avoids that several laser
instruments on one construction site may disturb each other.
SLEEP FUNCTION
In order to save energy the laser beam and rotation can be powered off by pressing button
Shield key
SLOPE TILT
+X
-X
-Y
+Y
SLOPE key
SLOPE up/down key
Sleep key
Figure 7: operation panel of remote control
TILT key
CALIBRATE
Confirm key of
self-calibration
Adjust key of
self-calibration
Direction key of
self-calibration
on the
remote control (the ON/OFF LED and the TILT LED will power off). To resume, the laser beam
and rotation can be startet by pressing this button again.
Important : During sleep mode only the button
Shield key
SLOPE TILT
+X
-X
-Y
+Y
SLOPE key
SLOPE up/down key
Sleep key
Figure 7: operation panel of remote control
TILT key
CALIBRATE
Confirm key of
self-calibration
Adjust key of
self-calibration
Direction key of
self-calibration
on the remote and the POWER switch on the in-
strument are available. After 30 min. in sleep mode the unit will auto power off. When leaving the sleep
mode the previous modes will maintain. It is not possible to power the unit on/off completely with the
remote control.