MISTRAL
ENGLISH
Guide for the installer
Page 0
Power up the system and check the LED condition as shown
in the table of the control board instructions.
Program the control board according to the needs by following
the given instructions.
4. TESTING THE AUTOMATED SYSTEM
Carefully check operating efficiency of the automated system
and of all accessories connected to it, paying special attention
to the safety devices.
Hand the “User’s Guide” to the final user together with the Main-
tenance sheet.
Explain correct operation and use of the automated system to
the user.
Indicate the potentially dangerous areas of the automated
system to the user.
5. MANUAL OPERATION
The reversible models has no release device. To move the
leaf by hand, just release the electric lock.
Before releasing the electric lock always make sure that the
system is not powered.
If the automated system needs to be moved manually due to a
power lack or to an operator malfunction, proceed as follows:
Cut power by means of the safety circuit breaker (even in the
event of a power lack).
Slide the protective cap, Fig.22/
a
.
Insert the key and turn it 90°, Fig.22/
b
.
Lift the control lever, Fig.22/
c
.
To release the operator turn 180° the control lever to the direc-
tion indicated by the arrow on the release system, Fig.22/
d
.
Open and close the leaf manually.
To hold the operator in manual operation the release device
should be left in its current positions and the system should
be without power.
5.1. RESTORING NORMAL OPERATION
To restore normal operating conditions, proceed as follows:
Ensure that the system is not powered.
Turn the release system 180° in the opposite direction of the
arrow.
Turn 90° the release key and remove it.
Close the control lever and the protection cover.
Power up the system and perform some movements in order
to check the correct restoring of every function of the auto-
mated system.
6. MAINTENANCE
In order to ensure correct operation and constant safety over time,
make a general check of the system every six months, paying
special attention to the safety devices. In the booklet “User gui-
de”, a form has been prepared for the recording of maintenance
operations.
7. REPAIRS
The user must not carry out any repairs or maintenance operations;
these must be effected only and exclusively by qualified GENIUS
personnel or GENIUS service centres.
8. AVAILABLE ACCESSORIES
For the available accessories see the GENIUS catalogue.
9. SPECIAL APPLICATIONS
Applications other than those described in the present manual are
EXPRESSLY FORBIDDEN
.
1.
2.
•
•
•
•
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
5.
