SM drivers are located. Windows should find the information on the disk and identify the device as
a GM56PCI-SM Modem. It then copies the files from the install disk to the computer.
Important: The install program will display a message box that reports Cannot locate file.... If
this occurs, browse and re-point to where the GM56PCI-SM driver files are located. Then click
OK. Installation will now complete.
On Data/Fax/TAM and Data/Fax/Speakerphone modems, another device is found after the modem
has been installed. Windows notifies you that it has found a Serial Wave Device for the modem
and prompts for a Wave Device driver. Re-point to the GM56PCI-SM driver location and click
OK.
When these two devices are installed, the GM56PCI-SM Modem Setup program runs.
The modem setup program for PCI does not prompt for user input during installation. It defaults to
USA country code and Domestic English as the language for the online Help file. If you wish to
change these settings, and/or the COM port selection, you may do so via the GM56PCI-SM
Control Panel application (Start->Settings->Control Panel, then double-click the GM56PCI-SM
Modem icon) after setup is complete. Also, for GM56PCI-SM Data/Fax/Speakerphone modems
the microphone and speaker gain selections may be done via the Control Panel application (under
the Advanced tab).
Also, DOS box support is disabled after the GM56PCI-SM is installed. After install is complete,
you must enable it via the Advanced tab in the GM56PCI-SM Control Panel application. Make
sure the DOS box check box is checked. If not, click it to check it, exit the GM56PCI-SM Control
Panel application and restart the computer. You must restart the computer to complete DOS box
enabling.
7
Installing GM56PCI-SM Software on Windows NT 4.0
Important -- The GM56PCI-SM software for Windows NT is Data/Fax only, there is no
speakerphone or TAM supported.
Windows NT 4.0 does not fully support plug and play (PnP). Therefore, after installing the modem
board in the computer and booting, the operating system will not automatically recognize that new
hardware is present. You must manually install the modem.
Note : Don’t click “Add New Hardware” to detect your modem.
Step -- Install the GM56PCI-SM modem driver
1. Path the driver direction under the supplied CD disc.
2. Double click the file “sm56set”to install your modem.
3. The wizard will now copy all the necessary files and install the GM56PCI-SM modem on your
PC.
4. When complete, your modem is ready to work.
8
Verifying Proper Modem Installation