Genie Z-51/30J, Service And Repair Manual

Page: 76 / 144

66 Z®-51/
31J
Part No. 1268553GT
October 2020 Service and Repair Manual
Turntable Rotation Components
3 Remove the safety pin from the engine pivot
plate latch.
Note: The engine pivot plate latch is located
under the engine turntable pivot plate at the
counterweight end of the machine.
4 Remove the center turntable cover retaining
fasteners. Remove the center turntable cover
from the machine.
5 Open the engine pivot plate latch and swing
the engine pivot plate out and away from the
machine.
6 Tag, disconnect and plug the hydraulic hoses
from the turntable rotation motor manifold. Cap
the fittings on the manifold.
WARNING
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
7 Attach a lifting strap from and overhead crane
or other suitable lifting device to the turntable
rotator assembly.
8 Remove the turntable rotation assembly
mounting fasteners.
9 Carefully remove the turntable rotation
assembly from the machine.
DANGER
Tip-over hazard. The machine
could tip over when the turntable
rotation assembly is removed if
the turntable rotation lock is not
in the locked position.
WARNING
Crushing hazard. The turntable
rotation assembly could become
unbalanced and fall when
removed from the machine if
not properly supported by the
overhead crane.