Genie SX-150, Operator'S Manual

Page: 45 / 77

Second Edition • Third Printing Operator's Manual
Inspections
Part No. 1262335 SX-150 • SX-180 43
Test Drive Tilt Cutout
82 Press down the foot switch.
83 With the boom fully stowed, drive the machine
onto a slope where the chassis angle is
greater than 4.5° along the Y-Axis (front to
back).
Result: The machine should continue to drive.
84 Return the machine to level ground and extend
the boom approximately 3 ft / 91.4 cm.
85 Drive the machine onto a slope where the
chassis angle is greater than 4.5° along the
Y-Axis (front to back).
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
86 Retract the boom to the stowed position.
Result: The machine should drive.
87 Return to level ground and raise the boom to
approximately 15° above horizontal.
88 Drive the machine onto a slope where the
chassis angle is greater than 4.5° along the
Y-Axis (front to back).
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
89 Lower the boom to the stowed position.
Result: The machine should drive.
90 Return to level ground and stow the boom.
91 Press down the foot switch.
92 With the boom fully stowed, drive the machine
onto a slope where the chassis angle is
greater than 3° along the X-Axis (side to side).
Result: The machine should continue to drive.
93 Return the machine to level ground and extend
the boom approximately 3 ft / 91.4 cm.
94 Drive the machine onto a slope where the
chassis angle is greater than 3° along the
X-Axis (side to side).
Result: The machine should stop once the
machine reaches 3° of chassis tilt and the
alarm should sound at the platform controls.
95 Retract the boom to the stowed position.
Result: The machine should drive.
96 Return to level ground and raise the boom to
approximately 15° above horizontal.
97 Drive the machine onto a slope where the
chassis angle is greater than 3° along the
X-Axis (side to side).
Result: The machine should stop once the
machine reaches 3° of chassis tilt and the
alarm should sound at the platform controls.
98 Lower the boom to the stowed position.
Result: The machine should drive.
99 Return to level ground and stow the boom.