Genie SX-150, Operator'S Manual

Page: 37 / 77

Second Edition • Third Printing Operator's Manual
Inspections
Part No. 1262335 SX-150 • SX-180 35
At the Ground Controls
1 Select a test area that is firm, level and free of
obstruction.
2 Turn the key switch to ground control.
3 Pull out the red Emergency Stop button to the
on position.
Result: The beacons (if equipped) should
flash.
4 Start the engine. See Operating Instructions
section.
Test Emergency Stop
5 Push in the red Emergency Stop button to the
off position.
Result: The engine should shut off and no
functions should operate.
6 Pull out the red Emergency Stop button to the
on position and restart the engine.
Test the Extendable Axles
Note: Start this test with the axles retracted.
7 At the ground controls, press and hold a
function enable/speed select button and press
the boom up button.
Result: The boom should raise approximately
10° and then stop. On the LCD screen, the
arrow next to the extend axle symbol will flash.
The boom should not raise unless the axles
are extended.
8 Press and hold a function enable/speed select
button and press the boom extend button.
Result: The boom should extend 1 ft / 30 cm
then stop. On the LCD screen, the arrow next
to the extend axle symbol will flash. The boom
should not extend unless the axles are
extended.
9 Push and hold a function enable/speed select
button and push the turntable rotate left button.
Result: The turntable should rotate 40° and
then stop. The turntable should not rotate
more than 40° unless the axles are extended.
10 Push and hold a function enable/speed select
button and push the turntable rotate right
button.
Result: The turntable should return to center,
rotate 40° to the right and then stop. The
turntable should not rotate more than 40°
unless the axles are extended.