Genie GSD106, User Manual

Page: 7 / 40

5
Chapter 3 - Quick Operating Guide
I. Wiring
II
. Setting Protocol and Baud Rate
The figure shows: Protocol: PELCO-D The figure shows: Auto detection protocol.
Baud rate: 2400 bps Baud rate: 2400bps
(Refer to detailed parameters in the next chapter)
III. Setting Dome Address
The figure shows: A Dome Address of 1
(Refer to detailed parameters in the next chapter)
This dip switch is located on the PCB in the dome
IV. Install Camera
Note
: 1 . Do not connect the camera and dome with FFC in an incorrect manner.
2.The installation fixing holes of for different camera may differ.
Set address for Dome
Protocol
Setting
Baud Rate
Setting
Protocol
Setting
Baud Rate
Setting
Turn the power Off when setting, and restart the dome after revision
Orange RS485A (+)
Yellow RS485B (-)
Controller of
the Dome
Yellow-Green Interphase Colour
Yellow-Green Interphase Colour
BNC Video Output
Red
Black
External Connection for Alarm Input/Output
AC24V Input
Connected to
Ground
Power Supply of Dome
Display