Genie GSD106, User Manual

Page: 37 / 40

35
2. User Logon Operation
Invoke Preset 92 for the Administrator logon.
Invoke Preset 93 for the Operator logon.
Factory Set Password : Administrator: 000000 Operator: 111111
Note: If the dome needs to be returned to the factory the Administrator password will be reset to default.
3. OSD Menu:
Enter “ 90+PRE+Enter” to access the PTZ’s OSD Menu.
4. Description of the Tour Function:
a) When entering “ 51+Enter ” the device enables the system default Tour. The device automatically
scans, point by point, from Preset No 1 to Preset No.16. If any of the positions have not been preset or been
cleared Tour does not scan them.
b) Dwell time at each preset position is 2 seconds.
5. Description of the Swing Function:
a) The Dome automatically Swings between two specified Preset positions.
b) Users can set the start point with “52+Enter” and the end point with “53+Enter”.
c) Swing speed set: The above sets a swing speed of three seconds, then “CALL+51+Enter” saves the Swing
speed. Use“CALL+52+Enter” to enable the Swing.
d) Dwell time of the swing at the “start” and “end point” is 2 seconds.
6. Intelligent Manually Pan Continuous Scan:
If you use the joystick to manually pan, for a minimum of 3 seconds, then press “CALL+101+Enter” the dome
remembers the direction of the manual pan and automatically pans continuously 360-degrees in the same
direction.