CAUTION
First read and follow the guidelines in the
Safety
section.
Replacing a Memory Card
CAUTION
Memory modules can be easily damaged by static electricity. Leave the module inside its static-proof
bag until it is ready for installation and make sure you are grounded before attempting this procedure.
Removing a Memory Card
Inserting a Memory Card
CAUTION
Only use memory cards approved for use in your computer. Failure to do so may void your warranty.
1. Hold the memory card by its edges with the edge-connector side towards the slot.
CAUTION
Do not touch the memory card anywhere except the edges.
2. Hold the card at a shallow angle (about 25 degrees) and insert the edge connector into the connector slot. The
1. Turn off the computer and disconnect the AC
adapter.
2. Turn the computer upside down and lay it on a flat
surface.
3. Remove the battery (
see Battery Removal
).
4. Carefully remove the two RAM compartment cover
screws and remove the RAM compartment cover
(1).
5. If a memory card is inserted, use your finger to
gently pull the tabbed latches in the direction of the
arrows (2). The card will pop up slightly.
CAUTION
Do not use tools to pull the memory
card latches. Tools may cause damage.
6. Pull upwards on the card and then slide the card out
(3).
Page 58 of 70
VR-2 Help
4/26/2007
file://C:\Documents and Settings\harwoodm\Local Settings\Temp\~hh3F7F.htm
