Switch Fabric and V6.2 Controllers
Switch Fabric Setup
032R440-000
Xedge 6000 Hardware
3-11
Issue 17
Installation & Setup Guide
XM Switch Fabric Module
The XM Switch Fabric module can control up to four slot controllers and is intended for use in the
Xedge 6160 desktop system. The XM operates at 50 MHz only (XH mode). The front panel LEDs
on the XM can be set to operate in three different display modes by setting jumper JP 2.
The jumpers on the XM Switch Fabric must be configured or checked before installing the module
in the chassis.
and
show the location and describe the function of pin pairs
on each jumper. Hold the board as shown with the component side facing you and the front panel
to the left. In this position, references to “upper” or “lower” in the table are the “upper” or “lower”
jumper positions.
Figure 3-5
XM Jumper Locations
FRONT PANEL
Jumper in upper position.
Jumper in lower position.
LEGEND
JP2
XM CIRCUIT BOARD
JP1
