Gendex GXS-700, User Manual

Page: 21 / 310

English
4-1
Chapter
4
Installation
GXS-700 is normally set up on a Personal Computer (PC) by a professional system integrator or
a software house. We advise against non-professional installation and configuration of the
GXS-700.
Installation of Software Driver
Before connecting the USB cable, carefully follow the procedure described below:
1. Install a compatible imaging software (such as VixWin Platinum) on the PC, following
the installation and configuration procedures contained in the imaging software
Operator Manual.
Important:
If upgrading to a new version of VixWin Platinum, make sure that all
acquisition and viewing workstations are upgraded to the latest version
of the VixWin software. Otherwise, image quality differences could be
observed on the same image depending on which workstation is used
to display it. Other imaging software packages may require similar
action; consult the appropriate Operator Manual or technical support
resource.
2. Check that the installed imaging software (such as VixWin) is NOT runnning.
Important:
GxPicture should NOT be installed for DEXIS and Dentrix Image imaging
software.
3. Insert the GxPicture CD supplied with the GXS-700 system in the CD-ROM drive and
follow the Windows “Guided Installation” instructions provided. The GxPicture CD
contains the USB driver for the GXS-700 system.
4. Once the GxPicture installation is complete, insert the Calibration File CD supplied
with the GXS-700 system in the CD-ROM drive and follow the Windows “Guided
Installation” instructions provided.
5. When the software installation is complete, connect the sensor to the computer and
follow the instructions on the screen. When you have completed the installation
procedure, the icon representing the GXS-700 driver will appear in the Windows
System Tray.
NOTE:
If nothing happens in the 10 seconds after you have inserted the GxPicture or
Calibration File CD in the CD-ROM, the CD-ROM auto-run has been disabled on
the computer. It is necessary to manually launch the “Setup” file which can be
found in the main directory of the ActiveX Driver CD-ROM.
6. Using GxPicture, ensure that the status icon indicates the ready state (green icon)
which verifies that the sensor is recognized (see “Status Icon” on page 5-1).
GXS-700.book Page 1 Wednesday, January 27, 2016 9:58 AM