User’s Guide
Chapter 7 – Reference Manual
Figure 58 – DNS Redirection Settings
The
DNS
server
or
DNS
address
can be obtained dynamically if DHCP, PPPoE and/or PPTP (for
DSL) service is enabled. To add
DNS
server manually click the
edit
button in the
action
column and
type in the
DNS
server’s IP address:
Figure 59 – Edit DNS Redirection Settings
IP address
– enter the primary or secondary DNS server’s IP address [in digits and dots notation].
Save
– click to save the new DNS server’s settings.
Network Interface | DHCP
The
P560
controller can act as a
DHCP
server
and/or as a
DHCP
relay
gateway
. The
DHCP
(Dynamic Host Configuration Protocol
)
service is supported on the LAN interfaces [eth0/ixp0/vlan[n]].
This service enables clients on the LAN to request configuration information, such as an IP address,
from a server. This service can be viewed in the following table:
Figure 60 – DHCP Configuration
By default the AC is configured to act as a
DHCP
server
.
Each LAN interface runs a different instance of the
DHCP
service. This service is configured by
defining an IP address range and WINS address for client workstations. Other settings, such as the
default gateway and DNS server address are configured automatically according to the interface
settings.
To see the complete
DHCP
service configuration, click the
details
button in the action column:
Figure 61 – DHCP Settings Details
Gemtek Systems
Page 59
