User’s Guide
Chapter 5 – Command Line Interface
SSH Connection
Make sure that
default
access
status
is enabled on the AC before attempting to
connect via
SSH
. Otherwise no
SSH
connection will be available.
Connect the Access Controller via LAN or WAN ports using the enclosed UTP cable and start a SSH
session (using an application as PuTTY). For example connect your device via the WAN port and
then make a SSH connection to host IP: 192.168.2.66 (default WAN interface IP).
Login to CLI mode prompt will be displayed automatically. Enter the administrator login settings (refer
to the next
section for details).
Login
Enter the administrator login settings in the displayed CLI command prompt.
The default administrator login settings:
Login:
admin
Password:
admin01
Figure 18 – CLI Login
After a successful login command prompt is displayed, the CLI is ready for commands. Press ‘?’ to
get a list of main commands:
Figure 19 – Main CLI Commands
‘
?
’ will not appear on the screen. While pressing this character, the display changes
to the desired help page. To enter ‘
?
’ as character type ‘
\?
’.
Connection
Connection
is a category of command that is related to the user’s connection with the device.
A full list of all available
connection
commands/subcommands and its parameters
is available in the Appendix section:
D) CLI Commands and Parameters.
In general, connection usage is as follows:
connection <command> <value>
To get a list of all available commands in the connection category type:
Gemtek Systems
Page 40
