User’s Guide
Chapter 5 – Command Line Interface
Status
Status
is a category of commands that’s displays:
General
devices
status (model, firmware version, uptime, memory)
All interface
network
settings (IP address/netmask, MAC address, gateway, RX/TX statistics)
Currently running
services
(DHCP, routes, port forward, telnet, SNMP, UAT, ..).
A full list of all available
status
commands/subcommands and their parameters is
available in the Appendix section:
D) CLI Commands and Parameters.
In general the
status
command usage is as follows:
Status <command>
To get the full list of the
status
commands, type:
status ?
Figure 32 – System Status Commands List
To get the general device status information, type:
status device :
Figure 33 – Device Status
Here you can find the current firmware
version
of your AC. This is important
information for support requests and for preparing firmware uploads.
System
System
is a category of commands that configures access to controller (telnet, AAA methods, L2
isolation, SNMP, UAT) and configuration: clock, NTP, syslog, trace.
A list of all available
system
commands/subcommands and their parameters are
available in the Appendix section:
D) CLI Commands and Parameters.
In general, the
system
command usage is as follows:
system <command> <subcommand1> <subcommand2> [-parameter] <value>
To get the full list of the
system
commands, type:
system ?
Gemtek Systems
Page 45