Gemsy GEM2210/1310, Operating Instructions Manual

Page: 38 / 94

7-15.压脚上升量的调整
Adjusting the work clamp lift amount
使 用 说明 书
Operation Instruction
①
②
③
④
③
<电磁 规格>
可以使用操 作盘在15mm～25mm之间进行设定。
<气压 规格>
压脚的最人 上升鼍为从针 板向上30mm。
1．送 入气压，踩下 脚踏开关①． 压脚②向上升 起。
2．旋 松压脚臂杆③ 的螺栓④[2个]，上 下移动来调
整压脚臂杆 ③。
<Solenoid specifications>
The operation panel settings can be used to adjust the height
to within 15 - 25 mm. (Refer to "5-7. Setting the work clamp lift
amount.")
<Pneumatic specifications>
The maximum lift amount for the work clamp is 30 mm above
the top of the needle plate.
1. Turn on the air, and depress the work clamp switch
①
to
raise the work clamp
②
.
2. Loosen the two bolts
④
of the work clamp arm lever
③
,
and move the work clamp arm lever
③
up or down to adjust.
7-16.空气压力的调整(空压规格)
Adjusting the air pressure (pneumatic specifications)
①
②
③
④
将调节器① 的舵轮②向上 拔起后再回转 ，使空气压力
调整到
0 . 5 Mpa 。
调整完了后 ，将舵轮②往 下按锁住。
如果调节器 ①内的瓶中积 有水时，按箭 头方向回转排
水旋栓③， 将水放掉。
(注意)请慢慢打 开气压栓④。
Lift up the handle
②
of the regulator
①
and then turn it to
adjust the air pressure to 0.5 MPa.
After adjustment is complete, push the handle
②
downward
to lock it,
If water has collected in the bottle of the regulator
①
, turn the
drain cock
③
in the direction indicated by an arrow to drain
the water.
(NOTE) Open the air cock
④
slowly.
8.故障检修
Troubleshooting
为 了防 止缝纫 机的 意外 起动， 请关掉 电源之 后进 行操 作
注 意
CAUTION
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
·
·
Please check the following points before calling for repairs or service.
If the following remedies do not fix the probIem, turn off the power switch and consult a qualified technician or the place of
purchase
．
·请 您在要求维修 或服务前，先 检查以下各项 。
·如 果以下方法仍 然不能解决问 题，关闭电源 开关，向受过训练 的技术人员或 经销商咨询。
29