Rev. 00 09/22
UA05
Maintenance / Repairs
•
45
Setting the support roller
If the gun or the linear guide unit starts to vibrate excessively during
operation, in most cases the cause lies in incorrectly set support roller!
Fig. 16: Support roller
In this case, proceed as follows:
1.
Switch off the power supply.
2.
Loosen the lock nut (
1
) on the grub screw (
2
)
3.
Loosen the screw (
3
) of the support roller axis
4.
Adjust the pressure on the roller (
4
) with the grub screw, so that the
linear guide unit can be moved only slightly with manual pressure
Support roller
is set too high
Linear guide unit
sluggish
Wear on linear guide
unit or tracking error
during operation
Support roller
is set too low
Gun extension tube
is not supported
Abrasion on the linear
guide unit
5.
Tighten the screw (
3
)
Tightening torque: 10 Nm
6.
Tighten the lock nut (
2
)
Check if the linear guide unit is blocked or runs rough!
► Adjust, if necessary!
The linear guide unit should run evenly and quietly again!
Maintenance of the position regulator
The position regulator does not require a preventive maintenance.
However, it is recommended to carry out the following inspections by the
user in regular intervals:
–
Check condition and tightness of the cable connections.
Summary of Contents for UA05
