Gehl SL3640E, Operator'S Manual, Page: 62 / 88

58 917334/BP0310
Starter will not
engage when key is
turned to START.
Seat or restraint bar switch
malfunctioning or not
activated. Replace switches as needed.
If engine still doesn’t start,
contact your dealer.
Poor connections to starter
relay in instrument panel. Verify relay connections.
Battery terminals or cables
loose or corroded. Clean terminals, cables and
retighten.
Faulty starter relay in
instrument panel. Contact your dealer.
Battery discharged or
defective. Recharge or replace battery.
Starter solenoid not
functioning. Troubleshoot circuit. Replace
the starter solenoid.
Ignition wiring, seat switch,
restraint bar switch, etc.
loose or disconnected. Check wiring for poor
connections, broken leads;
repair wiring or connection.
Starter or pinion faulty. Remove starter;
repair/replace as needed.
Work lights not
functioning properly.
Single light doesn’t work:
Light bulb burned out, faulty
wiring. Check and replace light bulb
as needed. Check wiring
connection to light.
No lights at all; 25-ampere
breaker tripped. Check circuit and locate
trouble before replacing fuse.
Faulty light switch or poor
ground. Replace light switch. Check
ground wire connections.
Lift/Tilt and/or drive
lock solenoids do not
work.
Wiring to solenoids
disconnected or faulty. Troubleshoot circuit, repair.
Faulty seat or restraint bar
switch. Contact your dealer.
Faulty solenoid valve coil. Contact your dealer.
Faulty hydraulic solenoid
relay in instrument panel. Contact your dealer.
Electrical System
Problem Possible Cause Remedy