Gehl SL3640E, Operator'S Manual, Page: 35 / 88

917334/BP0310 31
CHAPTER 4
OPERATION
Before starting the engine and operating the
loader, review and comply with all safety
recommendations in the Safety chapter of this manual. Know how to
stop the loader before starting it. Also, be sure to fasten and prop-
erly adjust the seatbelt and lower the operator restraint bar.
Before Starting the Engine
Before starting the engine and running the loader, refer to the Controls and Safety
Equipment chapter and familiarize yourself with the various operating controls,
indicators and safety devices on the loader.
Starting the Engine
The following procedure is recommended for starting the engine:
1. Carefully step up onto the back of the bucket or attachment and grasp the
ROPS handholds to get into the operator’s compartment.
2. Fasten the seatbelt and lower the restraint bar.
3. Verify the following:
¾
the lift/tilt, drive and auxiliary controls are in their neutral positions,
¾
the brake is on.
4. Push the throttle forward to half speed.
Note: When the key is turned to the RUN position, an indicator will light on the
instrument panel and a buzzer will sound momentarily to remind you to check
that your seatbelt is fastened.
5. Turn the keyswitch to the START position.
Important: Do not engage the starter for longer than 15 seconds at a time.
Longer use can overheat and damage the starter. Allow the starter to cool for
20 seconds between uses.
After the engine starts, allow a sufficient warm-up time before attempting to
operate the controls.
Important: If the warning lights do not go off, stop the engine and investigate the
cause.
Cold Starting Procedure
Do not use starting fluid (ether) with preheat
systems. An explosion can result which can
cause engine damage, injury or death.
WARNING
WARNING