gefran ADL300 EPC v2, User Manual, Page: 48 / 64

____________________ _
ADL300-EPCv2- User Guide
Page 48 of 64
05.12 – FLOOR ARRAY
The Self Study command is used to detect the position of the cams that indicate the position of the floors in
the lift shaft. These positions are detected automatically by performing a series of movements. The following
positions are stored for each floor: A Low, B Low, A High, B High.
The values read in this phase are stored in the parameters contained in this menu.
No direct floor call or movement commands are possible (except jog and zero cycle) unless a Self Study
command has been correctly executed.
Position of cams floors 0 to 31
n B Low A High
Floor number Position of lower edge
of cam B
Position of upper edge of
cam A
# m m
This allows to compensate the difference between the expected level for the car stop and the level that
the car really stop, when the car go from the bottom to the top.
This allows to compensate the difference between the expected level for the car stop and the level that
the car really stop, when the car go from the top to the bottom.
This parameter allows the selection of the floor where the edge of the cams will be set (by par. 11074
and 11076).
Menu Par Description UM Type FB BIT Def Min Max Acc Mod
5.12.1 11048
Correction Fwd m FLOAT 0.0000 RW FVS
Menu Par Description UM Type FB BIT Def Min Max Acc Mod
5.12.2 11050 Correction Rev m FLOAT 0.0000 RW FVS
Menu Par Descrizione UM Tipo FB BIT Def Min Max Acc Mod
5.12.3 11066 Floor Selection INT 0 0 31 RW FVS
cam A
cam B
Line of the
floor
Positive direction
A High
B High
A Low
B Low