Gecko in.clear 0605-500002, User Manual, Page: 5 / 46

4
in.clear user manual
• For Canada, in.clear (using Bromitron Bromine Generator Technology) must only be used with sodium bromide
(such as BromiCharge) scheduled or registered under the Pest Control Product Act. For USA, the sodium bromide
(such as BromiCharge) must be registered under EPA.
• Read and follow this manual carefully and make sure to save it for later. This manual contains important information
on in.clear's installation, use and safety recommendations. It is your responsibility to install and use your in.clear
unit safely.
• The in.clear must be connected to a circuit protected by a ground fault interrupter device (GFCI) in North America
or residual current device (RCD) having a rated residual operating current not exceeding 30 mA in Europe.
• Make sure all electrical power is off before installing the in.clear unit. If the supply cord is damaged, it must
be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
• Use only an electrical cord in good condition to power the in.clear.
• Follow all aspects of the local and National Electrical Code(s) when installing the in.clear Automatic Bromine
Generator.
• Always clean or replace your filter cartridges at regular intervals, otherwise part of the bromine generated
by in.clear will only serve to oxidize the dirt accumulated in the filter.
• Do NOT add any other sanitation chemicals in the spa other than registered sodium bromide
(such as BromiCharge).
• Do not add chemical products for pool or spa directly into the skimmer. This may damage the cell.
• The cell is installed after the heater in the circulation pump line.
• Operating the in.clear at reduced sodium bromide (such as BromiCharge) levels will shorten the life of the cell.
Maintaining overly high sodium bromide and bromine levels above recommended range can contribute
to corrosion of spa equipment and may damage components of the spa.
• Do not open the in.clear unit; there are no serviceable parts inside.
• Disposal of the product: the in.clear unit must be disposed of separately in accordance with the local
waste disposal legislation in force.
• This unit is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
• To reduce the risk of injury, do not allow children to operate this device.
• The in.clear may not be suitable for in ground spas, it may affect some materials used in their construction.
• The unit must be installed in a location that is inaccessible to a person in the bath or spa and must be located
or fixed so that it cannot fall into the bath or spa.
• The unit is not designed to be submersed but may be installed underneath the waterproof skirt of the spa.
Aeware®, Gecko®, and their respective logos are Registered Trademarks of Gecko Alliance Group.
in.k200™, in.xe™, in.ye™, in.yt™, and in.clear™, and their respective logos are Trademarks of Gecko Alliance Group.
BromiCharge™ and its logo are Trademarks of Bromitron Corporation.
All other product or company names that may be mentioned in this publication are tradenames, trademarks
or registered trademarks of their respective owners.
Warnings! Important safety instructions
Warnings