Gecko in.clear 0605-500002, User Manual, Page: 20 / 46

in.clear user manual
19
The stand can be used for
floor mounting and for wall
mounting.
The stand includes the
required screws to mount
the device to the stand.
The mounting screws to
attach the stand to the spa
are not included.
The following material is recommended:
4- # 10 screws of appropriate length with round,
truss or pan head.
4- washers 12 mm OD x 1.5 mm thickness
(1/2" OD x 1/16”).
Select the most appropriate location for in.clear and
firmly attach each stand to wooden base with 2 screws
backed by 2 washers.
in.clear installation with stand
Gecko # 9920-101464
www.geckodepot.com
Floor and side mounting
Fig.A: in.clear installation scheme with circulation pump
Note: The pressure in the piping must be at least 3 psi when water is circulating
spa filter
circulation pump
11.4 to 151 liters/min
(3 to 40 US GPM)
water jet
heater
spa
in.clear
Make sure there are no kinks in the plumbing.
Water flow must run from bottom to top
if installed vertically.
If water flow is as low as 11.4 l/min (3 GPM) and
the in.clear is to be installed horizontally, an air gap
may appear at the top which may decrease the
performance of the unit. In this case, raise the outlet
1" above the water inlet level.
We do not recommend installing the linked version
of the in.clear on a heat recovery system, as the
in.clear forces filtration and risks raising the water
temperature above the Set Point.
The in.clear must be installed on a circulation pump
if one is present.
We do not recommend installing the in.clear on a
spa equipped with a dual-speed pump. The in.clear
works only when the pump is running; therefore
a dual-speed pump will need to run 8-10 hours for
optimum bromine production. This may be difficult
for a large pump to do in warm weather, without
overheating the spa.
Install the in.clear on the pressure side on a 11.4 to
151 l/min (3 to 40 US GPM) flow line. Do not to
exceed 151 l/min (40 US GPM) to prevent excessive
electrode wear and damage to the in.clear unit.
Installation
Warnings!
in.clear installation