Gecko in.clear 0605-500002, User Manual, Page: 21 / 46

20
in.clear user manual
•
Install the in.clear
before the spa is filled
with water.
•
The in.clear system
must be installed in
an upright position or
horizontally.
•
Install the in.clear on
the pressure side of the
pump, after the pack.
(see Fig. A )
•
Installing valves on both
sides of the in.clear may
help for maintenance
purposes.
Slide the two plastic union
nuts over the in.clear unit's
threaded ends and tighten
the nuts.
Hand tighten!
Do not use tools!
Connect the in.k200
keypad to the keypad port
on the in.clear unit.
Gecko
# 52202000
www.geckodepot.com
Gecko
# 0699-300007
www.geckodepot.com
Use adapters to connect
the in.clear system to
19 mm (3/4") tubing or
directly to 50 mm (2")
tubing.
Power cable
Plug power cable into
direct or unswitched
output of the spa pack.
The in.clear must
be protected by the
same ground fault
interrupter (GFCI)
circuit as the spa
system.
The input must be
240 V. A blinking
“AC” message on the
keypad means that
the input signal is
not 240 V, probably
120 V. Please check
connection.
Linked version only:
Plug the cable with
the low voltage in.link
connector into the CO
port of the spa pack. If the
CO port is in use, unplug
the accessory and replug
it into the CO port of the
in.clear.
Communication
connector
1. Secure the device in place and attach to plumbing
For an optimal connection
to spa plumbing, please
note that we recommend
these compression fittings
& nuts.
2. Install the keypad on the spa (see Installing the in.k200)
3. Connect the keypad and low voltage accessories and connect power
The exact location and the method of installation of the in.clear may vary depending on the plumbing design
of the spa.
Water
flow
Installation