Gecko in.clear 0605-500002, User Manual, Page: 22 / 46

in.clear user manual
21
The keypad should be installed directly onto the spa
(or very close to it) so that it is easily accessible to the
user. For a skirt mount installation the keypad should
be installed directly on a spa panel (make sure it is still
easily accessible to the user).
•
To install the in.k200, drill two 25 mm (1”) diameter
holes at 67 mm (2 5/8”) from center to center
as illustrated.
•
In the case of a skirt mount installation, start by
pilot drilling the hole centers using a 3 mm (1/8”) drill
bit, drilling from the finished side of the spa to prevent
chipping. Using the appropriate hole saw slowly drill
two 25 mm (1”) diameter holes at 67 mm (2 5/8”) from
center to center as illustrated.
•
Cut out the material between the two holes
(see illustration).
•
Clean the installation surface and route the keypad
cable from the wall cutout to the in.clear unit.
•
Peel the adhesive gasket from the back of the keypad,
insert it in the cutout and align it correctly, then ensure
it's properly glued by gently pressing evenly on
the entire surface.
If the keypad is equipped with an optional holder plate
remove the two wing nuts from the back of the keypad
and remove the mounting bracket.
Insert the keypad into the opening you have cut out.
Put the mounting bracket and the wing nuts back on
their respective bolts and fix the keypad securely in place
(see illustration).
∅
1"
(25 mm)
Gasket with adhesive
Mounting
bracket
1"
(25 mm)
3
5/8
"
(92 mm)
2 5/8"
(67 mm)
1"
(25 mm) dia.
drill
∅
1"
(25 mm)
∅
1"
(25 mm)
Note: It is the installer’s responsibility to ensure that no obstructions (cables, piping, etc.) are present below the deck at
the drill hole location.
Note: If the installation location is not perfectly even (e.g. wood surface), make a silicone joint between the installation
location and the back of the unit to ensure a proper seal around it.
in.k200 drill template
Ø 0.657"
16.68 mm
TYP.
3.550"
90.17 mm
0.942"
23
.92 mm
CUT ALONG
DASHED LINE
Installation
in.k200 installation