21. C-R/PHONES CONTROL
Controls the level of the signals output to the PHONES connector and the C-R L and R connectors.
22. LEVEL METER
This 12-segment LED METER shows the level of the signals selected by the selection switches described in
[20] above (the level to the C-R OUT and PHONES connectors). The “0” point corresponds to the standard
output level. The indicator lights up red when the output hits the clipping level.
23. POWER INDICATOR
This indicator lights up when the mixing console's power is ON.
24. ST GRAPHIC EQUALIZER
This 7-band equalizer adjusts the sound of the signal send to the ST OUT connectors. The equalizer is
effective only if the GEQ switch is set ON (pressed in, amber LED on switch lights up). The equalizer cuts or
boosts each band (125Hz, 250Hz, 500Hz, 1kHz, 2kHz, 4kHz, and 8kHz) over a range of ±12dB.
25. PHONES CONNECTOR
Connector for headphones. This is a balanced stereo phone-type (¼” TRS) output connector.
NOTES:
The signals monitored by this connector are selected by the LEVEL-
METER SIGNAL switches and the channel PFL switches.
26. UTOPIA DIGITAL EFFECTS
PROGRAM DIAL
Selects the internal UTOPIA 32-BIT DSP to be applied. You can select from 16 effects, as shown in the table.
1
HALL 1
9
VOCAL ECHO 1
2
HALL 2
10
VOCAL ECHO 2
3
HALL 3
11
VOCAL ECHO 3
4
ROOM
12
VOCAL ECHO 4
5 PLATE 1
13 VOCAL REVERB 1
6 PLATE 2
14 VOCAL REVERB 2
7 PLATE 3
15 VOCAL REVERB 3
8 GATE REVERB
16 VOCAL REVERB 4
For the full range standalone effects, please check out GECKO® UTOPIA DSP 2206 DIGITAL MULTI
EFFECTS.
PARAMETER CONTROL
Adjusts the parameter (depth, speed, etc.) for the selected effect.
AUX1 PRE / AUX2 PRE CONTROLS
Adjust the level of the signals sent from the internal UTOPIA 32-BIT Digital Signal Processor (DSP) unit to
the AUX1 and AUX2 buses.
______________________________________________________________________________________
7
7
© GECKO MUSIC GROUP. All Rights Reserved.
