DETAILED
PARAMETERS
39
260
USER
GUIDE
Bypass
When "Bypass" is "on", the box behind it is highlighted in green; when the
box is in white, it means that "Bypass" is off. When "Bypass" is "on", the
Delay is turned off; when "Bypass" is "off", the Delay is turned on.
Units - Seconds, Feet or Meters
To select the unit of measurement for the delay.
Step Coarse/Fine
When the unit is based on seconds, coarse adjustments are made in
1.04ms increments, while fine adjustments are made in 0.02ms
increments. When the unit is based on feet, coarse adjustments are
made in 1.17ft increments, while fine adjustments are made in 0.02ft
increments. When the unit is based on meters, coarse adjustments are
made in 0.36m increments, while fine adjustments are made in0.01m
increments.
Length
To set the amount of Speaker Alignment delay time. The maximum length
of pre-crossover delay is different from that of the post-crossover. The
delay range of the pre-crossover is: Seconds: 0.00-59.58ms, feet: 0.00-
67.15ft, meters: 0.00-20.44m. The delay range of the post-crossover is:
Seconds: 0.00-19.89ms, feet: 0.00-22.42ft, meters: 0.00-6.82m.
4.9 Input Routing (IN)
The signal routing begins at the
INPUT ROUTING block of the
unit. These parameters are user
adjustable on all programs. The
parameter setting interface is
illustrated in the following
diagram. The slider of the
parameter selected or being
edited is highlighted in blue.
