GeChic On-Lap 2501 Series, Manual

Page: 7 / 32

4
Chapter 2 Installation Instructions
Section 1 Install the Protection Cover
1. Use the Cover as the stand
Open the Cover. Turn the Cover backward
of the On-Lap Monitor and put the Prod-
uct on the table
Fig.: Turn the Cover backward of the Prod-
uct and put it on the table.
2. Remove and Install the Cover
Open the Cover and put the Cover with
the monitor flatly on the table. Fix the
monitor by one hand and use another
hand to push the Cover latch 5mm aside.
Then remove the cover in the direction
of arrow.
When install the Cover, insert the left
latch of the Cover to the enclosure hole
of On-Lap Monitor first. Then push the
right latch of the Cover 5mm aside and
insert the latch to the right enclosure
hole of the monitor.
Section 2 Install the Stand 4
(Optional)
Step1. Remove the Cover
Step2. Assemble Stand 4
Select the desired angle placement to assemble
Stand 4. Before assembly, check if X plate is
properly inserted onto slot.
Step3. Place On-Lap 2501 Series onto Stand 4
Place On-Lap 2501 Series onto Stand 4. Stand 4 is
positioned at the bottom center of monitor.
Fig.: Fix the monitor by one hand and
use another hand to push the Cover
latch aside. Then remove the cover.
Fig.: Place On Lap 2501 Series onto Stand 4