Geca Roma Wi-Fi, Complete Manual

Page: 47 / 60

Device name
6 - Enter the data as shown in Figure 4.
7
- Press the “ ” button at top top right to send the settings to the programmable thermostat.
The programmable thermostat’s display will show “ Att ” (Wait) (Fig. 5) and within a few seconds
the Home Screen (Fig. 6) will return.
The Signal Quality symbol “ ” stops flashing when the programmable thermostat has connected
to the selected Wi-Fi network.
The mobile device will then create the new device and show its control screen.
After a few seconds, the screen will update, showing the
programmable thermostat ’s param-
eters and you will be able to communicate with it.
N.B. If within a minute the mobile device’s screen does not update the programmable thermostat’s STATUS, press the
“ ” icon and re-select the device you have just created.
WARNING: When the programmable thermostat connects to the Wi-Fi network for the first time,
it performs a set of synchronizations with the server during which the programmable thermostat’s
buttons may not be active. The operation takes a few seconds.
N.B. : It is advisable to keep the Wi-Fi Router always turned on.
Fig. 4
47
Enter a name for the device (such as Home ).
Enter the SSID, i.e. the name of the Wi-Fi network connection to
which the programmable thermostat must connect. (for example
Home Wi-Fi ).
You can press the “ ” button to search for available Wi-Fi net-
works (this function is valid only for adding a "New device").
When the search is complete, select the
Wi-Fi network .
WARNING: If no Wi-Fi network is detected after 15 seconds,
repeat the operation.
Enter the password, if used (for protected Wi-Fi networks ) to
connect to the Wi-Fi network .
Enter a PIN to use subsequently to link another mobile device to
the programmable thermostat (see the
Add mobile device sec-
tion).
Device name
SSID
Wi-Fi password
PIN
DHCP, IP ADDRESS, etc.
The following settings are for expert users.
We recommend changing them only if actually needed.
L U
+H -H
-C
+C
L U
Fig.6
Fig. 5