Geberit ACO 102, Operation Manual

Page: 14 / 208

14
Commissioning
B
102
4-0
0
1
© 01
-20
1
2
Commissioning
Inserting the pressing jaw
Prerequisites
Pressing tool is switched off.
WARNING
Danger of crushing by exposed parts
`
Do not hold any parts of your body or other objects in between the pressing jaws
`
Keep your fingers away from the area of the roller if there is no pressing jaw inserted
CAUTION
Damage to the device caused by incompletely pushed-in retaining pin
`
Push the retaining pin in completely and lock it
1 Turn the retaining pin by 180° to the front and pull it out (see cover page in the front, figure A).
2 Insert the pressing jaw in the pressing tool (see cover page in the front, figure B).
3 Push the retaining pin in until the stop position is reached and turn it by 180° to the rear (see cover page in the
front, figure C).
Charging and inserting the rechargeable battery
CAUTION
Damage to the device if incorrect rechargeable battery is used
`
Make sure that the voltage of the rechargeable battery corresponds to the details on the specification plate of
the tool
Read the operating instructions for the battery charger for information on how the battery charger functions.
Remove the rechargeable battery from the pressing tool before transporting and storing it; otherwise the
rechargeable battery will run flat.
1 Charge the rechargeable battery before commissioning.
2
Insert the rechargeable battery in the pressing tool from the rear (see cover page in the back, figure D).
Result
Pressing tool is in standby mode. No LED lights up.
Operation
Pressing with pressing jaws
Prerequisites
- Pipe ends are deburred and clean
- Pipe and pressfitting have been fitted together in accordance with the installation instructions
The procedure for pressing depends on the type of pressing jaw and is therefore described in the operating
instructions of the pressing jaw.
1
To start the pressing sequence, press and hold the start button for at least one second.
Result
The hydraulic valve switches off the pressing sequence after the pressing operation has been completed. The end
of the pressing sequence is indicated by the motor switching off.