Label print
12
GeBE E + F GmbH • www.gebe.net • GeBE Doc.No.: SMAN-E-657-V1.4 Thermal Printer GPT-4672/4673
Parameter 19: Standard Setting := 0d
Label-distance print head <-> Black mark sensor in li-
nes (1/8 mm):
This parameter controls how long printing commences
after a black mark has been recognized. This distance
includes printing and form feed until the ticket ends.
Therefore it is not imperative for the black mark to be at
the beginning of the ticket. This setting permits to
“move” a black mark to any position.
Parameter 20: Standard Setting := 3d
Label-Flags
Bit 0:
enable label mode (1: label mode on)
Bit 1:
0: internal PE sensor
1: AUX1 used for label control
Bit 2: 1: increases P19 value about 265 lines
Bit 3-7: future use (has to be set to zero)
Parameter 39: Standard Setting := 0d
This parameter indicates which kind of sensor is
connected (reflex/fork light barrier).
Bit polarity:
0 = Reflex light barrier
1 = Fork light barrier
Sensor
Param-Bit
NPE
Bit 0
AUX1
Bit 1
AUX2 Bit 2
AUX3 Bit 3
AUX4
Bit 4
Cutting:
A (feed „A“) has to be added after the FF command if
the ticket needs to be cut after printing. The
subsequent area „D1“ cannot be used for printing
because it is part of the next ticket.
Hint 1:
Printing of the next ticket can commence
during the feed to the Cut-Position!
Hint 2:
The GPT-46xx is capable of advancing paper
to be cut and subsequently retracting the
paper to the next printing position. The sensor
must not „see“ any black marks during this
process.
Distances:
sensor, print head, cutter
in mm
GPT-4673 GPT-4672
B: sensor - print head
15
13,5
A: print head - cutter
13,5
12
Label mode can be configured by means of several
printer parameters. For standard tickets, only the
parameter 20 needs to be changed from a decimal
value of 0d to 3d. Parameters are saved to user settings
by using the command format:
<ESC>V<Param><Value>.
Setting label control:
Parameter 16: Standard Setting := 254d
Label length in mm:
This setting indicates how long the device looks for
black marks before the search is canceled. This value
should be significantly longer than the length of the
label or ticket.
Parameter 17: Standard Setting := 16d
Length of recognition of black mark in lines (1/8 mm):
This parameter controls how many black mark lines has
to be recognized that a black mark becomes valid. For
instance, black marks will be recognized quickly if the
parameter is set to a low value, such as 4d. On the
other hand, some elements other than black marks,
such as pre printed text, might also be recognized as
black marks. The standard setting 10d will ignore pre-
printed elements of < 1mm.
Parameter 18: Standard Setting := 80d
Length of black mark or distance to PE-Recognition in
lines (1/8 mm):
This parameter controls after how many paper-end lines
the paper-end condition is met. The PE-Error is deleted
as soon as new paper is detected. A line feed is
necessary, and the value should be about 1 mm larger
than the utilized black mark size. Too large of a value
will cause a delay in PE-recognition.
