SIZING PTO SHAFT
18
STEP 1:
Cutting the PTO shaft to length.
NOTE:
Be sure to cut equal lengths
of each PTO shaft section. Clamp end
of PTO shaft in a vice and cut off
shield where marked. (
Fig. 1-A
& 1-B
)
STEP 2:
Using cut section of the shield as a
guide, cut shaft off the same amount
(
Fig. 2
)
STEP 3:
Repeat steps 1 and 2 for other PTO
shaft section.
STEP 4:
Use a file to deburr PTO shafts. Clean
up all chips, burrs, and fillings from
both ends of the PTO shaft.
Figure 1-A
Figure 1-B
Figure 2
