QUESTIONS?
USE THIS PROBLEM SOLVER
●
●
PROBLEM
“ERROR’’APPEARS
IN THE DISPLAY
CONTROL PANEL ON
YET MICROWAVE OVEN
WILL NOT OPERATE
“PROBE” APPEARS
IN THE DISPLAY
LOWER OVEN WILL
NOT OPERATE
LOWER OVEN LIGHT
DOES NOT WORK
ELECTRONIC PADS
WILL NOT WORK
ELECTRONIC DISPLAY
PANEL GOES BLANK
OR BLINKS
FOOD DOES NOT
BROIL PROPERLY
IN LOWER OVEN
POSSIBLE CAUSE
●
When using the Temp Cook function,
have entered a temperature
than
or more than
●
Door opened
the Auto cycle
Auto Cook function. Close the door and
press the START pad.
●
Incorrect
of the Auto Defrost code on the guide. Reset the oven.
●
The
pad not pressed.
●
Door not securely closed.
●
function was pressed. Press the. CLEAR/OFF pad to cancel it.
Numbers not entered after pressing the TIME COOK pad.
●
Finished temperature not entered after pressing the TEMP COOK pad.
The
pad pressed accidentally.
●
No code number entered after pressing either the AUTO ROAST, AUTO
COOK, or AUTO DEFROST pads.
●
Probe not inserted properly or not used during Auto Roast or Temp Cook Hold.
●
The probe not inserted properly into the oven receptacle or food.
●
The probe not used, although the AUTO ROAST or the TEMP COOK HOLD
pad has been pressed.
●
Difficulty may be in the main distribution panel of your house by a blown
oven circuit fuse, a tripped oven circuit breaker, the main fuse or the main
circuit breaker, depending on nature of the power supply. If a circuit breaker is
involved, reset it. If the control box uses fuses, the oven fuse (a cartridge-type)
should be changed BUT ONLY BY SOMEONE FAMILIAR WITH
ELECTRICAL CIRCUITS. If after doing one of these procedures, the fuse
blows or circuit breaker trips again, call for service.
●
The oven controls are not properly set.
●
The door is left in locked position after cleaning.
●
Light bulb is loose or is burned out.
●
Switch operating the oven light is defective.
●
The oven is in the
function.
●
Clock not set. Press the CLOCK pad and enter the time. Press the START pad.
●
If it cannot be reset by pressing pads, electrical service to your residence has
caused interference signals on the main power line. Disconnect your cooking
center at the main fuse or circuit breaker panel. Wait one minute and reconnect
power. Reset the clock.
●
The OVEN SET knob not set on BROIL position.
●
The OVEN TEMP knob not set correctly.
●
Door not open to the broil stop position.
●
Improper shelf position is being used. See the Broiling section.
●
Necessary preheating was not done.
Food being cooked on a hot pan.
●
Cookware is not suited for broiling.
●
Aluminum foil used on the broiler rack has not been fitted properly and slit.
(continued next
49
