
OPERATING THE SELF-CLEANING OVEN
(continued)
How
to Set the Oven for Cleaning
1. Turn the OVEN SET and OVEN TEMP knobs to
CLEAN. The controls will snap into final position
when the CLEAN location is reached.
The oven is programmed to clean for
3 hours, but you
may change the Cleaning Time by pressing the CLEAR
pad and the number pads to enter a different cleaning
time from 1 to
hours.
3.
To begin cleaning immediately, press
START
the START pad. The display shows
the Stop Time—in this example, 3
hours from the time the cleaning
operation starts.
You’ll know cleaning has started when the cleaning
NOTE:
●
“E
EE” appears on the display if you enter a Clean
Time less than or more than
hours. If this
happens, press the CLEAR pad and begin again.
●
No other function of the regular lower oven can be
used until the self-clean cycle is over and the oven
door is unlatched. You may use the microwave oven
during cleaning time.
To Stop a Clean Cycle
1. Push the CLEAR pad.
2. Slide the latch handle to the right as far as it will go. You
not be able
to open the door right away unless the oven temperature is at a safe level.
a Clean Cycle
After cleaning is complete, the oven door will stay
locked until the oven cools. If you cannot slide the
to unlock the door, allow additional time
for cleaning.
Never force the latch handle. The latch slides easily.
Fording the latch handle may damage the door lock.
Turn the Oven Set knob to
and the oven Temp
knob to WM. Press the CLEAR pad.
You may notice some white ash in the oven. Just wipe
it up
a damp cloth after the oven cools.
How to Delay Start of Cleaning
To Delay Start of cleaning:
1. Follow the directions in the Before a Clean Cycle
section and then steps 1 and 2 of the How to Set the
Oven for Cleaning section.
c1
2. Press the STOP TIME pad and the
STOP
number pads for the time of day you
TIME
want the cleaning
to be finished.
If white spots remain, remove them with a
filled steel wool pad. Be sure to rinse thoroughly with
a vinegar and water mixture. These deposits are
usually a salt residue that cannot be removed by the
clean cycle.
If the oven is not clean after one clean cycle,
repeat the cycle.
NOTE: No functions can be programmed before the
door automatically unlocks.
3. Press the START pad.
u
START
NOTE: The oven automatically figures the Starting
Time so cleaning will end when you want it to.