9
GEAppliances.com
18
Display
Displays the approximate time remaining
until the end of the cycle.
NOTE: The cycle time is affected by the
water pressure in your home and the
balance of the load in the washer. You
may see the time remaining on the display
increase to accommodate a slower spin
speed to handle unbalanced loads.
On some models, cycle status is also
displayed and certain features such as Delay
Wash or Steam are shown indicating they
have been selected.
If an out-of-balance condition is detected
by the washer, the Spin light will blink
during the remaining portion of the
cycle and will stay illuminated for a short
time after cycle completion. On some
models, there is also a “Load Rebalancing”
message displayed. When this occurs, the
washer is taking actions to correct the
out-of-balance condition and complete the
cycle normally. In some cases, the washer
may not be able to balance the load and
spin up to full speed. If you notice the load
is more wet than usual at the end of the
cycle, redistribute the load evenly in the
wash tub and run a Drain + Spin cycle.
14
15
Volume
(on some models)
This button has two functions:
To change the loudness of the end of cycle
signal, press the button as many times as
needed to reach the desired volume. There
are four sound levels including OFF.
To turn the button sounds ON/OFF, press
and hold the button for 3 seconds.
Lock Controls or Lock
(depending on model)
You can lock the controls to prevent any
selections from being made. Or you can
lock or unlock the controls after you have
started a cycle.
Children cannot accidentally start the
washer by touching buttons with this
option selected.
To lock the washer, press and hold the
Lock Controls or Lock button for 3
seconds.
To unlock the washer controls, press and
hold the Lock Controls or Lock button for
3 seconds.
A sound is made to indicate the lock/
unlock status.
The indicator light above the button will
illuminate when the controls are locked.
NOTE: The Power button can still be used
when the machine is locked.
Tumble Care or Extended Tumble
(on some models)
Ext Tumble
or
Tumble
17
or
(depending on model)
(appearance will vary
and not all features
on all models)
Freshly tumbles your garments periodically
for up to 8 hours after the wash cycle is
complete to lessen the setting of wrinkles
and creases when you are not able to
move clothing to the dryer right away.
At the end of the cycle, the display will
scroll “END” and after ten minutes the
Tumble Care or Extended Tumble will
begin. It can be stopped at any time by
pressing the Power button.
Note: The Tumble Care or Extended Tumble
option cannot be added to the My Cycle
feature.
16
Cycle Signal
(on some models)
Use the Signal pad to change the
volume of the end of cycle signal.
Press the pad until you reach
the desired volume.
Summary of Contents for GFW400
Page 25: ...25 Notes GEAppliances com ...
