DIRECTION 5854713-100, REVISION 2
VENUE FIT™ SERVICE MANUAL
8-8
Chapter 8 - Replacement Procedures
P R E L I M I N A R Y
3) Gently separate the back cover from the touch display panel.
8-2-4-5
Rear Cover Installation Procedure
1.) Attach the rear cover to the front panel and tighten the 7 captive screws
NOTE:
Make sure the eDP cable connector is not pinched when closing the back cover.
2.) Install the battery.
3.) Install the battery cover.
4.) Switch
On
the battery power switch.
5.) Close the battery power switch silicon cover
Note: IMPORTANT:
Remove all labels from the old back cover and adhere them on the back side of
the newly installed back cover.
Figure 8-37 Removed Rear Cover
Perform the checks listed in
-
section
Summary of Contents for Venue Fit
Page 299: ......
