1997 REFRIGERATORS
GLOBAL NEW GENERATION
SxS
© General Electric Company 1997
17
Control Housing
To remove the control housing -- first
remove the pad, the pad support and the
escutcheon. Then, remove the screws at
the front of the housing. Pull the
housing forward about 1-inch and
disconnect the 6-wire harness connector
from the left end of the control module
(printed circuit board).
To reinstall the control housing --
reconnect the 6-wire harness connector to
the control module. Push the control
housing firmly into position and
reinstall the screws. Then, reinstall
the escutcheon, pad support and pad.
Control Module
To remove the control module -- first
remove the control housing. Then, remove
the knobs from the selector switch and
light switch by pulling them straight
downward. Disconnect the 4-wire harness
connector from the control module.
Remove the screws at the ends of the
cover and lift the cover from the control
housing. Grasp the edges of the control
module and lift it out of the slots in
the control housing.
To reinstall the control module --
position it into the slots in the control
housing so that the 4-pin connector is at
the end nearest the 4-wire harness
connector. Then, reinstall the cover.
Reconnect the 4-wire harness connector to
the control module and dress the harness
downward to prevent pinched wires when
the control housing is reinstalled.
Reinstall the switch knobs, control
housing, escutcheon, pad support, and
pad.
