1997 REFRIGERATORS
GLOBAL NEW GENERATION
SxS
© General Electric Company 1997
42
Module Reinstallation
When reinstalling the control module, make sure
the vinyl sleeve is fully positioned over the
temperature control capillary and the foam gasket
is positioned over the end of the foam nozzle.
Carefully insert the capillary and wiring harness
through the foam insert in the compartment
divider. Then position the foam nozzle into the
foam insert and engage the pin at the lower right
mounting support into the locator hole in the back
of the liner. Engage the module onto the top
center support. Drive all three mounting screws
and reattach the ground wire to the back of the
liner.
Connect the wiring harness plug at the right side
of the evaporator fan housing. Position the
temperature control capillary behind the auger
motor cover, in front of the fan housing and
against the liner. Dress the capillary so that it
does not restrict air movement through the foam
nozzle.
