![background image](http://html1.mh-extra.com/html/ge/spacemaker-gtup270emww/spacemaker-gtup270emww_technical-service-manual_4077085055.webp)
– 55 –
6. From inside the tub, remove the two 1/4-in.
hex-head screws that attach the funnel to the
washer.
7. Pull and unsnap the thermistor from the top of
the
fi
ll funnel.
Note:
A wire tie is located underneath the harness
entry cover.
4. Remove the 1/4-in. hex-head screw and the
harness entry cover from the tab.
5. Release 3 wire ties that attach the ATC sensor
wiring to the rear of the unit.
8. Disconnect the wire harness connected to the
control board at location J12.
9. Pull the wires and connector down through the
harness entry.
Note:
Make certain the gray rubber gasket is in
place on the thermistor when reassembling.
Harness Entry Cover
ATC Thermistor
Wire Ties
1 Tie under cover
Tab
Gasket
Summary of Contents for Spacemaker GTUP270EMWW
Page 15: ...15 Airflow...