– 48 –
The lid lock now completes a circuit from J7 pins 1
to 2 at the control board. The control will be able to
activate the drive motor for spin. If the lid lock fails
to complete the drive motor circuit, 120 VAC will be
present at control board J7 pins 1 to 2.
12 OHMS
900 OHMS
To Drive Motor
12 OHMS
900 OHMS
The lid will remain locked until the end of the spin
cycle and the control board has received 0 rpm
feedback from the motor Hall sensor. The control will
then unlock the lid by energizing the lock solenoid
through pin 7 to 6.
If the lid lock fails to complete the circuit to J7 pins
1 and 2; the control will make 5 attempts to lock the
lid. (An audible click will be heard each time.) If after
5 attempts the lid lock routine fails to lock the lid, the
control will pause for 4.25 minutes and attempt the
lock routine again (3 times). If the lid will not lock, the
control will enter a failure mode and display a failure
code to the user.
12 OHMS
900 OHMS
Summary of Contents for Spacemaker GTUP270EMWW
Page 15: ...15 Airflow...