![background image](http://html1.mh-extra.com/html/ge/spacemaker-gtup270emww/spacemaker-gtup270emww_technical-service-manual_4077085053.webp)
– 53 –
Water Valve
Each water valve coil has an approximate resistance
value of 1.1K
:
.
To remove the water valve:
Note:
To replace the water inlet valve; the entire unit
must be removed from its location.
1. Remove the entire unit from its location.
2. Turn off the water supply to the appliance.
3. Remove the
fi
ll hoses from the water valve.
4. Remove the cover assembly. (See
Cover
Assembly
.)
Note:
To increase access to the valve, it may be
helpful to remove the 2 damper rods at the front of
the outer tub and lean the tub forward.
5. Disconnect the wire harnesses from the valve.
6. Remove the outlet hose from the valve.
7. Remove the 1/4-in. hex-head screw that
attaches the water valve to the rear of the unit.
Disconnect
Disconnect
Outlet Hose
Transmission Assembly
To remove the transmission assembly:
1. Remove the spin basket. (See
Spin Basket
.)
2. Remove the outer tub. (See
Outer Tub
.)
3. Invert the tub assembly on a protected surface.
4. Remove the 3/8-in. hex-head bolts that hold the
transmission assembly to the bottom of the tub.
(16 bolts for 27-in model and 14 bolts for 24-in.
model.)
Tub Seal
5. Transfer the motor and belt to the new
transmission assembly.
Important:
A new tub seal is supplied with the new
transmission assembly. Press the new seal into the
bottom of the tub before installing the transmission.
Important:
After installing the transmission
assembly to the outer tub, transfer the
fl
at washer
to the transmission spin tube before installing the
spin basket.
Summary of Contents for Spacemaker GTUP270EMWW
Page 15: ...15 Airflow...