GE Simon Security System, Installation Instructions Manual

Page: 15 / 68

Simon Security System 8
Installing the
System
This section describes how to open the panel for mounting, mount the panel, connect
sirens, hardwire contacts, and the AC power transformer.
Materials Needed
• Pencil
• Phillips Screwdriver
Opening the Panel Cover and Chassis
Tabs at the top of the panel secure and release the front cover and the chassis. The
plastic hinges on the panel bottom allow the cover and chassis to swing down and out
of the way (see Figure 2).
X10 Unit Number Assignements
Unit # Result
1 - 8 Used for sensor-activated, time-activated, and entry/exit delay
lights.
Sensor-activated lights are enabled and disabled by pressing the
LIGHTS Sensor Activated button on the panel.
Time-activated lights are enabled and disabled by pressing the
LIGHTS Time Activated button on the panel.
If using the universal module to operate a device, be sure to assign
a unique unit number.
The STAR button on the KeyChain Touchpad activates the universal
module controlled device or to turn on special lights if programmed.
9 Used for remote siren or light control.
For remote siren use, sirens with this setting sound alarms, arming
level beeps, status beeps, and trouble beeps.
For light control, lamp modules with this setting are controlled by an
all on or all off command.
10 Used for remote siren or light control.
For remote siren use, sirens with this setting only sound alarms.
For light control, lamps will flash according to selected arming level
and are controlled by an all on or all off command.
11 - 16 Used for lamp modules and controlled by an all on or all off com-
mand.