– 34 –
To replace a light bulb,
use a new 130-volt halogen
bulb, not to exceed 50 watts.
Note:
Higher wattage bulbs will damage your oven.
•
Using gloves or a dry cloth, remove the bulb
•
from its packaging. Do not touch the bulb with
bare
fi
ngers. Oil from bare
fi
ngers may cause
hot spots on the glass surface and lead to
premature failure of the bulb. If you do touch the
glass, clean it with alcohol prior to installation.
Push the bulb straight into the receptacle all the
1.
way.
Place the tabs of the glass cover into the
2.
grooves of the socket. Turn the glass cover
clockwise 1/4 turn.
Note:
For improved lighting inside the oven, clean
the glass cover frequently using a wet cloth. This
should be done when the oven is completely cool.
Reconnect electrical power to the oven.
3.
Lockout Valve
The range lockout feature (on some models), will
allow the user to lock out the surface burners,
oven burners, and control panel so they cannot be
activated. (See
Control Features
.) The purpose of the
lockout valve is to shut-off the gas supply to the
surface burners when this feature is selected.
Note:
The cooktop is locked out when the oven is in
self-clean mode. (See
Control Features
.)
The lockout valve assembly consists of a valve lock
motor, cam and switch assembly, lock valve, and
mounting plate.
The lock motor is energized when the control is set
for RANGE LOCK-OUT. The control RY4 relay will
close and complete the circuit that supplies the
voltage to the valve lock motor.
(
Continued next page
)
COOKTOP
LOCK
COOKTOP
UNLOCK
CN6
COOKTOP
LOCK
COOKTOP
UNLOCK
CN6
SWITCH CIRCUIT- LOCKOUT VALVE CLOSED
SWITCH CIRCUIT- LOCKOUT VALVE OPEN
Note:
When the door is either being locked or
unlocked, both lock switches will be in the open
position.
Rear Cover Removal
To access the rear cover it is necessary to remove
the range from its installation. (See
Range Removal
.)
The cover is attached to the range with six 1/4-in.
hex-head screws located along the outer edge and
six 1/4-in. hex-head screws located on the back.
